Table of Contents
Advertisement
3 - Verifying Installation
Once the host adapter and hard drives have been installed into the chassis, boot-up the system to verify that
the hardware is properly recognized.
1. Power on the system. If the system detects the presence of the adapter, the RocketRAID BIOS Utility
will be displayed during boot up.
2. Press Ctrl+H to access the RocketRAID adapter's BIOS Utility.
The BIOS Utility will display information about hard drives attached to the adapter.
Make sure all attached drives are detected by this utility. If any of the hard drives are not detected, power
down the system and check the power and cable connections.
11
Advertisement
Table of Contents
