Special Functions; Erasing Edge Shadows (Erase) - Sharp DIGITAL LASER COPIER/PRINTER Operation Manual

SPECIAL FUNCTIONS

You can use various functions for scanning and transmitting images. Set these functions as needed.

ERASING EDGE SHADOWS (ERASE)

The erase function is used to erase the shadow lines on images produced when scanning thick originals or books.
The erase modes that can be selected are shown below. The erase width is approximately 1/2" (10 mm) in its initial
setting.
Your machine
USING ERASE
1
In scanner mode, touch the [SPECIAL
MODES] key.
ADDRESS REVIEW
SPECIAL MODES
FILE
ENTRY
TTINGS QUICK FILE
2
Touch the [ERASE] key.
AM ERASE
R
2in1
3
Select the desired erase mode.
ERASE
CENTER
EDGE EDGE+CENTER
ERASE ERASE ERASE
EDGE ERASE
Erases shadows at edges
that appear when scanning
thick originals or books.
Transmission to
CENTER ERASE
other machine
Eliminates shadow lines
produced by the bindings
of bound documents.
EDGE + CENTER ERASE
Eliminates shadow lines around
the edges of images and
eliminates the shadow at the
center of images.
If the address book screen
appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(page 11).
CA
Select one of the three
erase modes. The
selected key will be
highlighted.
The other machine
Using edge erase
Combining "edge erase"
with "dual page scan" on
the following page
4
If desired, set the width of the edge to be
erased (touch the
set the width).
CENTER
(0 1)
1/8
inch
5
Touch the outer [OK] key.
OK
CANCEL OK
6
Send the image as explained in "BASIC
TRANSMISSION METHOD"
15).
NOTE
To cancel the erase function, touch the [CANCEL]
key on the erase setting screen. (step 4)
25
key or the key to
The erase width can be
set from 0" (0 mm) to 1"
(20 mm) in 1/8" (1 mm)
increments.
You will return to the
screen of step 1 and an
erase icon will appear
next to the
[EXPOSURE] key.
To cancel erase, touch
the [CANCEL] key.
(pages 12 to