Sending An Image; Basic Transmission Method - Sharp DIGITAL LASER COPIER/PRINTER Operation Manual

SENDING AN IMAGE

BASIC TRANSMISSION METHOD

1
Make sure the machine is in scanner
mode.
the [MODE SWITCH] key to select the E-MAIL/
FTP mode or the INTERNET-FAX mode.
2
Load the original.
NOTE
You cannot load documents in both the automatic
document feeder and on the document glass and
send them in a single transmission.
3
Check the original size.
300 x 300dpi
RESOLUTION
PDF MMR(G4)
FILE FORMAT
AUTO 8½ 11
X
ORIGINAL
NOTES
To scan a two-sided original, refer to
To rotate the document image 90° before
transmission, see page
When the [IMAGE
SEND] key light is on,
the machine is in
scanner mode. If the
light is not on, press the
[IMAGE SEND] key.
Depending on the
feature to be used, touch
For detailed information
on loading an original,
refer to page 4-3 of
"Operation manual (for
general information and
copier operation)".
The original size is
automatically detected.
If you loaded a non-
standard size document
or wish to change the
scanning size, touch the
[ORIGINAL] key and set
the document size.
(Refer to page 20.)
page 19.
20.
4
If needed, adjust the resolution setting.
(Refer to page
EXPOSURE
300 x 300dpi
RESOLUTION
PDF MMR(G4)
FILE FORMAT
AUTO 8½ 11
X
ORIGINAL
5
If needed, adjust the exposure setting.
(Refer to page
AUTO
EXPOSURE
300 x 300dpi
RESOLUTION
PDF MMR(G4)
FILE FORMAT
AUTO 8½ 11
X
6
If needed, select the file format. (Refer to
page 24.)
EXPOSURE
300 x 300dpi
RESOLUTION
PDF MMR(G4)
FILE FORMAT
AUTO 8½ 11
X
ORIGINAL
7
Touch the [SEND SETTINGS] key.
ADDRESS ENTRY
SEND SETTINGS
NOTES
You can skip the send settings (Proceed to step
18). If you skip these settings, the subject and the
file name that were set on the Web page and the
sender name that was set with the key operator
program (if the name is not registered, the default
is the administrator name for the Web page) will
automatically be used for transmission.
Subjects, file names, and senders are stored
using the Web page. Up to 30 subjects and file
names, and up to 999 senders can be stored. You
can input the subject and the file name directly
using the procedure on the
12
23.)
The initial factory setting
is "300x300dpi"
MAIL/FTP mode)
"STANDARD" (Internet-
Fax mode).
23.)
The initial factory setting
is "AUTO".
The initial factory setting
is "PDF MMR(G4)".
This step is
necessary for Scan to
FTP or Scan to Desktop.
Go directly to step 18
(page 14).
next page.
(E-
or
not