Table of Contents
Advertisement
Communication Panel
The Communication Panel tab, shown in Figure 6, is located on the
left-side of the About tab. The PTZ-35 MS / PTZ-50 MS can communicate at the 2400, 4800, 9600
& 57600 baud rates and both pan/tilt as well as camera control can be accessed. To access the
device, simply choose the camera control switch and select the correct COM port that is connected
to your PC. Once the correct COM port has been selected then communication can proceed. Note
that selecting the Pelco address will only configure the GUI and not change the device address
itself.
Figure 7: Select COM Port and Pelco Address
If you are having trouble communicating with the device, be sure to check all connections and
confirm the COM port selection at the PC and the device. Also, confirm the standard RS-232 cable
is a working cable and not faulty.
Figure 8: PTZ-35 MS / PTZ-50 MS Communication panel
427-0016-00-10 Revision 120
Copyright © 2008 FLIR Systems, Inc.
11
Hide quick links:
Advertisement
Table of Contents
