Tips: When zooming place target in center of display, then zoom. Use "Stabilize Image" when
vehicle is in motion –see Vibration above.
Joystick drift
: If the camera moves or zooms without touching the joystick, this is called "drift".
Follow these instructions to correct the problem:
1. Recycle power without touching joystick during the flashing LED portion of the turn-on
sequence.
2. To recalibrate the joystick:
a. Remove power.
b. Depress and hold the 'Gear – DN' white button (top right).
c. Apply power.
d. Wait 10 seconds and release button.
Caution: The unit should be operated by a person other than the driver while vehicle is in use.
When not in use, remove power jack from Joystick Display Unit.
Figure 23: Operational Directions on back of Joystick Display Unit
427-0016-00-10 Revision 120
Copyright © 2008 FLIR Systems, Inc.
27