Programming The Queue Time-Out - Norstar Compact ICS 6.0 Manual

162 / Programming Hunt Groups
1. Place the programming overlay on a T7316, M7310 or M7324
telephone.
² ¥ ¥ Û ß ß Ü Ý Ý
2. Press
Password: .
Û Ü ß Ý ß
3. Press
Terminals&Sets .
4. Press ' until the display shows System prgrming .
5. Press ≠ . The display shows Hunt groups .
6. Press ≠ . The display shows Show group .
7. Enter the Hunt Group number you want to program (1-6).
8. Press ≠ . The display shows Member DNs: .
9. Press ' until the display shows If busy: .
10. Press CHANGE to set the mode: BusyTone , Overflow , Queue .
¨
11. Press

Programming the queue time-out

This setting allows you to program the number of seconds a call remains in
the Hunt Group queue before it is routed to the overflow position.
1. Place the programming overlay on a T7316, M7310 or M7324
telephone.
² ¥ ¥ Û ß ß Ü Ý Ý
2. Press
Password: .
Û Ü ß Ý ß
3. Press
Terminals&Sets .
4. Press ' until the display shows System prgrming .
5. Press ≠ . The display shows Hunt groups .
6. Press ≠ . The display shows Show group .
7. Enter the Hunt Group number you want to program (1-6).
8. Press ≠ . The display shows Member DNs: .
9. Press ' until the display shows Q Timeout: .
10. Press CHANGE to set the queue time-out: 15, 30, 45, 60, 120, 180 .
Compact ICS 6.0 System Coordinator Guide
(ADMIN). The display shows
to exit or ' to continue programming.
(ADMIN). The display shows
(CONFIG). The display shows
(CONFIG). The display shows
P0992670 03