Changing Button Programming - Norstar Compact ICS 6.0 Manual

150 / User Preferences
Sub-headings in User Preferences
User prefernces
Model
Button prgrming
User speed dial
Call log opt'ns
Dialing opt'ns
Language
Display cntrst
Ring type

Changing button programming

Press ≠ at Button prgrming . The display shows the number of
buttons on the telephone (an example is shown in Displays at the end of this
section).
If the telephone has a CAP module, you can press CAP1 to see the buttons
on the module.
Press ' to move through all the buttons on the telephone. Refer
to ''Default button assignments'' on page 144 for button number mapping
for each type of Business Series Terminal and Norstar M-series telephones.
Use the display buttons to change the programming for a button. User
Preferences programming cannot change the buttons that are used by lines,
intercom, and the handsfree feature.
The display buttons used in button programming
Moves you out of a setting without making any changes to it.
CANCL
Erases the button.
CLR
Programs the key as an autodial number for an internal or an
TEL#
external number. If it is an external autodial number, you have to
choose a line, line pool, or the routing table for the call to use.
Used when you are setting up an external autodial number. Press
CHANGE
CHANGE until you see the type of line or pool you want the number
to use.
Compact ICS 6.0 System Coordinator Guide P0992670 03