Changing A User Speed Dial - Norstar Compact ICS 6.0 Manual

Press to store a feature code on the button.
FEATR
Locates a specific button on a telephone by entering its number.
FIND
Button numbers are shown in the illustrations.
Takes you to a list of feature codes. Press ' to move
LIST
through the list and press OK when you see the feature you want to
program on the button.
Information about individual displays you may see is described at the end
of this section.

Changing a User Speed Dial

1. Press ≠ at User Speed Dial . The display shows the number
of speed dial codes that are available.
2. Press ' to see the first speed dial code (256).
3. Press ' to move through all the speed dial codes.
4. Press ≠ at the code you want to change.
5. Press CHANGE and enter the telephone number the same way you
would dial it on the telephone.
6. Press OK .
7. Press ' and choose the line (or enter a code for a line pool)
the speed dial code should use.
Use the line pool code to select a particular line pool for use with Speed
Dial. If you select Use routing tbl , a line or pool is chosen by the routing
programming according to the initial digits in the number.
The route you choose for a User Speed Dial code must be one that the
telephone can use. For example, if the telephone does not have access to
Line Pool B and you use that pool code with the speed dial code, the code
does not work.
To change a system speed dial code, see ''Adding or changing a system
speed dial'' on page 29.
P0992670 03
User Preferences / 151
Compact ICS 6.0 System Coordinator Guide