Fcc Notification - Intuicom RTK Bridge User Manual

7 FCC Notification

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: 1) This device may not cause harmful interference and 2) this device must accept any
interference received, including interference that may cause undesired operation. This device
must be operated as supplied by Intuicom, Inc. Any changes or modifications made to the device
without the express written approval of Intuicom may void the user's authority to operate the
device.
CAUTION: The 900MHz Wireless RTK Bridge models have a maximum transmitted output
power of 955mW. It is recommended that the transmit antenna be kept at least 23 cm away from
nearby persons to satisfy FCC RF exposure requirements.
The 2.4GHz Wireless RTK Bridge models have maximum transmitted output power of 500mW.
It is recommended that the transmit antenna be kept at least 23 cm away from nearby persons to
satisfy FCC RF exposure requirements.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Whenever any Intuicom module is placed inside an enclosure a label must be placed on
the outside of that enclosure which includes the module's FCC ID.
Revision 1.4
Section 7: FCC Notification
42 © 2009 Intuicom, Inc.