Intuicom RTK Bridge-X Installation Manual
Integration with topcon agi-3 and agi-4
Hide thumbs
Also See for RTK Bridge-X:
- Installation manual (19 pages) ,
- Installation manual (9 pages) ,
- Installation manual (9 pages)
Related Manuals for Intuicom RTK Bridge-X
Summary of Contents for Intuicom RTK Bridge-X
- Page 1 Installation Guide ® RTK Bridge Integration with: ® ® ® Topcon AGI-3 and AGI-4 Intuicom, Inc. 4900 Nautilus Ct. Ste. 100 Boulder, CO 80301 (303) 449-4330 www.intuicom.com...
- Page 2 Intuicom reserves the right to make changes to this document without notice. Unless otherwise agreed to in writing, Intuicom assumes no responsibility or liability for the use of this document or for the infringement of any copyright or other proprietary right and Intuicom shall deem nothing contained in this document a warranty or guarantee.
-
Page 3: Required Information
The AGI-3 and/or AGI-4 receiver(s) are typically configured to accept RTCM format RTK corrections from an Intuicom RTK Bridge®-X which in turn has been configured to connect to a GPS/GNSS reference network. The intended audience for this document is a dealer or integrator familiar with the Topcon receivers and access to the Set-up menus as well as general familiarity with the Intuicom RTK Bridge–X. -
Page 4: Installation Instructions
Section 2: Installation Instructions 2 Installation Instructions Below is the installation Diagram for the recommended installation of the Intuicom RTK Bridge–X utilizing the equipment noted above. Diagram 1 Version 1.0 Intuicom, Inc. - Page 5 Signal Ground AGI-3 cable pinout • Configure the pin-out on the Deutsch connector on the RTK Bridge-X to AGI-3 data/power cable to match the appropriate pin-out. See Pin-out Diagram 2 Pin-out Diagram 2 choose either Port A or D for AGI-3...
- Page 6 Section 2: Installation Instructions • Using the Intuicom RTK Bridge-X to AGI-3 data/power cable, connect the RTK Bridge-X data port to the data port on the AGI-3 as shown in Diagram 2. Diagram 2 Example of how to connect the data power cable into the boot for the AGI-3 Data connector •...
- Page 7 Section 2: Installation Instructions • Select Correction Source • Select RTK (External Modem) • Select Correction Type (RTCM 2 or 3) Version 1.0 Intuicom, Inc.
- Page 8 The AGI-3 and/or AGI-4 should now be receiving the correction from the RTK Bridge and the Monitor should display an RTK Fix. For Technical Support of the RTK Bridge-X, Intuicom recommends “Intuicom Remote Support”, please contact Intuicom for details on this real- time support program. For general technical support, please contact us at support@intuicom.com...
Need help?
Do you have a question about the RTK Bridge-X and is the answer not in the manual?
Questions and answers