Startup Sequence - Intuicom RTK Bridge User Manual

3.2

Startup Sequence

Once the unit is properly configured and physically setup it goes through a startup sequence
when power is attached and power button pressed.
1. The PWR LED on the front panel should immediately light RED (If the Profile
Button is held during power up (for about 20 seconds) all Profile (1-4) LEDs will
flash and the unit will enter Antenna Aiming Mode).
2. The currently active profile LED (1-4) will blink – press the Profile button to change
the active Profile at this point. If the Profile is changed, the unit will re-start with the
new Profile.
3. The Cellular signal is sampled – and the SIG light will indicate the current Cellular
signal strength (Solid RED, Flashing RED, or OFF).
4. Assuming the signal strength is sufficient, the embedded cellular modem will registr
with the carrier's network and the unit will connect to the Internet, a successful
connection is indicated by the MDM light turning RED.
5. The unit will attempt to connect to the Server IP and Port number specified in the
profile, if this connection is successful, the SVR LED will turn RED.
6. If in NTRIP mode, the unit will attempt to connect to the configured mountpoint
using the configured username and password. If this failed, the SVR LED will turn
off.
7. If the unit is configured to send its Real-Time, or Static GPS message, it will do so
within 10 seconds. The GPS LED will indicate if the internal GPS is tracking, or if a
Static GPS message is being sent.
8. The TXD LED will begin to blink as corrections are received and broadcast out the
internal data radio and/or the Data port on the front panel. Operation will continue
until interrupted by power off, or loss of cellular signal.
Revision 1.4 27
Section 3: Operation
© 2009 Intuicom, Inc.