Dtmf Programming - ITS Telecom CGW-D Operation Manual

Item
Public Call Through
Allow Public Call
Through
Max. Digits to Dial
Enable Restriction
Table
Subscriber's Timer
Reset Day in
Month
Call Back/Through
First Digit Timeout
Operation
Call Divert
Number
APPLY

3.2.3 DTMF Programming

The CGW- D device can be programmed using DTMF commands. To program the unit perform the
steps as follows:
1. If the unit is connected to a PBX, remove the cable from the FXO connector on the unit front
panel.
2. Connect an analog telephone directly to the FXO connector.
3. Dial *900 and enter the password (1234 by default).
4. Use the commands in the following table for programming.
Function
Enables to provide a dial tone to any incoming
cellular caller, which can make calls subject to the
restrictions set in Prefix Restriction Numbers
window and Max. Digits to Dial parameter.
Contains a value that limits the number of digits
that a cellular caller can dial. Active only when
Allow Public Call Through checkbox is selected.
Applies the settings defined in the restrictions
table.
Contains a value that defines the day of the
month in which the subscriber's timer will be
reset.
Enables to select the action that gateway will
perform if the caller starts dialing after the First
digit timeout parameter defined in the Dialing
Parameters window has elapsed.
When this occurs, the gateway will either
disconnect the call or forward it to the FXS
direction.
Enables to divert the call to an alternate cellular
gateway. A number in the field enables this
feature; an empty field disables this feature.
Applies all changes.
CGW-D
Default Range/
Option
Deselected
Inactive
1 1-28
Disconnect Disconnect
FW to
Phone
Empty
3-15