Usb Driver Installation; Usb Serial Driver Installation; Found New Hardware Window - ITS Telecom CGW-D Operation Manual

Installation and Operation Guide
2.3

USB Driver Installation

The USB installation driver software is included on the supplied CD. Please note, that you must select a
driver that corresponds to the operation system installed on your PC. If an update is required, you can
find the drivers you need on the following web page: http://www.ftdichip.com/Drivers/VCP.htm.
There are two stages of USB driver installation:

2.3.1 USB Serial Driver Installation

To install a serial driver, perform the steps as follows:
a. Power the device using the 9V DC external power supply.
b. Plug a USB cable into the device and the PC USB port. Found New Hardware window appears
(Figure 2-7).
This window should appear automatically when the new hardware is detected.
If it is not detected automatically, perform the steps as follows:
a. Right-click My Computer icon and select Manage from pop-up menu. Computer Management
window appears.
b. Click the Device Manager branch. The device management tree appears on the right.
c. Right-click Universal Serial Bus controllers and select Scan for hardware changes from pop-up
menu. After a few seconds Found New Hardware Wizard window appears (Figure 2-8).
2-4
Figure 2-7. Found New Hardware Window