1080P Configuration With The Vidyoroom Hd220 Appendix - Vidyo VidyoRoom HD-220 User Manual

1080p Configuration with the VidyoRoom HD220 Appendix

Note: The VidyoRoom system must be version 2.0.3 or higher to support 1080p
encode resolutions.
To enable the 1080p/30fps transmit format for calls on the VidyoRoom HD220
system, you must properly configure both the camera and the room system.
Prior to connecting the Sony EVI-HD3V or EVI-7V camera to the VidyoRoom,
select the resolution desired and configure the camera to output that video for-
mat. To set the camera's resolution, locate the POT screw control dial in the rear
of the camera marked SYSTEM SELECT. The numbers on the POT dial correspond
to the video resolution and frame rates output from the camera to the VidyoR-
oom HD220 system.
The Minrray camera is set via VISCA, so VISCA must be connected.
Setting Video Formats\
You set video formats on the back of the camera as shown below:
Video Format Table
Switch Position Video Format
0 1080p / 60 fps
1 1080p / 30 fps
2 1080i / 60 fps
3 720p / 60 fps
4 720p / 30 fps
5 VGA/60 fps (Letterbox)
8 1080p / 50 fps
9 1080p / 25 fps
A 1080i / 50 fps
B 720p / 50 fps
C 720p / 25 fps
For configuration supporting 1080p/30fps, set the Sony EVI-HD7V camera to
TM
capture in 1080i/59.94 mode. The correct setting for this option is position #2
on the SYSTEM SELECT POT dial control.
48
EVI-3V / EVI-7V
7V Only
7V Only
7V Only
Both
Both
Both
7V Only
7V Only
7V Only
Both
Both