Replacing The Light Bulbs - Dacor Wall Oven Use & Care Manual

Optional Cookie Sheets
• Clean aluminum cookie sheets with a solution of detergent
and warm water. Since aluminum can scratch, you need to
use the soft side of a sponge. A way for you to keep cookie
sheets cleaner is to use parchment paper over the cooking
surface during baking. The parchment paper will also prevent
food from sticking.

Replacing the light Bulbs

Light bulb replacement is considered to be a homeowner
maintenance operation.
NOTE:
If the lights do not work, before replacing them, please
consult the problem Solution Guide on page 28.
WARNING:
To prevent electrical shock and/or personal injury, make
certain that the oven and light bulb(s) are cool and that
power to the oven has been turned off at the main power
supply before replacing the light bulb(s).
WARNING:
Always ensure that the lens cover is in place when using the
oven. The lens cover protects the bulbs from breakage that
can be caused by high temperatures or being bumped.
To Replace the light Bulb(s), follow These Steps:
NOTE:
Do not touch the halogen light bulbs with your fingers.
halogen light bulbs are sensitive to the oils from your hand.
The oils from your hand will stick to the bulb and cause it
to burn out faster than normal. Use a glove when handling
them.
• Turn off power to the oven at the main power supply.
• Each light assembly consists of a light fixture housing, a
removable lens cover, and a 12 Volt halogen light bulb. See
page 7 for the location of the light fixtures.
• Gently insert the pointed end of the supplied pry stick under
the center edge of the lens cover on the side facing the oven
door. Hold your hand under the lens for support, then pry out,
pulling the lens cover straight out.
Light bulb
Lens cover
Light Bulb Replacement
ImpORTANT:
Use the pry stick with caution. Do not cause uneven stress
on the lens cover.
• Pull the light bulb straight out of the light socket (do not turn).
• Using a glove, insert the new bulb into the socket. Replace
the bulb only with Dacor
authorized Dacor
• Reinstall the lens cover by aligning the cover over the
opening and gently pressing it into its original position. Be
sure that the side of the lens cover with the cutaway is in the
front, by the socket.
• Turn the power to the oven back on at the main power
supply.
Light fixture
on inside of oven
Light socket
27
Part No. 92317, available from any
®
parts dealer.
®