Replacing The Light Bulbs - Dacor EOR series Use And Care Manual

Replacing the Light Bulbs

warning
• To prevent electrical shock and/or personal injury, make
certain that the oven and light bulb(s) are cool and that power
to the oven has been turned off at the main power supply
before replacing the light bulb(s).
• Always make sure the lens covers are in place when using
the oven(s). The lens covers protect the light bulbs from
breakage caused by high oven temperatures or mechanical
shock.
• Replacing the lens cover without lining up the cut-out with the
light socket will damage the light fixture.
• Do not use a screwdriver to remove the lens.
Light bulb replacement is considered to be a homeowner
maintenance operation. if the lights do not work, before
replacing them, please consult the Problem Solution
Guide on page 29.
important
Do not touch the replacement halogen light bulbs with
your fingers. Halogen bulbs are sensitive to the oils
from your hand. the oils from your hand will stick to
the bulb and cause it to burn out faster than normal.
Care and Cleaning
Light
bulb
27
To replace the light bulbs...
1. replace the light bulb only with Dacor part number
100429. see the page 28 for ordering information.
2. turn off power to the oven at the circuit breaker panel
or fuse box.
3. hold your hand under the lens for support and gently
pry it loose using a spatula or table knife. pull the lens
cover straight out.
4. grasp the old bulb and pull it straight out of the
socket.
5. using a glove, insert the new bulb into the socket.
6. as you reinstall the lens cover, line up the cutout on
the inside rim with the light socket. gently press it
into its original position.
7. turn the power to the oven back on at the main power
supply.
8. reset the clock (see page 8).
Light
socket
cutout on inside
rim of lens