Replacing The Light Bulbs - Dacor DISCOVERY EO Use And Care Manual

Optional Baking Stone
• Wash the optional baking stone with hot water and
scrub it clean before you use it for the first time. Do
not use any soap or detergents to wash the stone.
The stone is porous and soap will get trapped inside.
The trapped soap will affect the flavor of the food
cooked on it. Don't be alarmed if the stone gets stains
on it after it is used for a while. Stains do not affect
the stone's ability to bake properly.
• When you need to remove large food particles from
the baking stone, use warm water and a scrub brush.
If there is a lot of oil build-up, it may smoke and
create odors. If you need to remove the oily build up,
use a scouring pad or brush to remove it. You may
also use a paste of baking soda and water to scrub
small stained spots off.

Replacing the Light Bulbs

• To prevent electrical shock and/or personal injury,
make certain that the oven and light bulb(s) are cool
and that power to the oven has been turned off at
the circuit breaker panel or fuse box before replacing
the light bulb(s).
• Always ensure that the lens cover is in place
when using the oven. The lens cover protects the
bulbs from breakage that can be caused by high
temperatures or being bumped.
• replacing the lens cover without lining up the cutout
with the light socket will damage the light fixture.
• Do not use a screwdriver to remove the lens.
Light bulb replacement is considered a homeowner
maintenance operation. If the lights do not work, before
replacing them, please consult the Before You Call for
Service section.
ImPortant: Do not touch the replacement halogen light
bulb with your fingers. Halogen bulbs are sensitive to the
oils from your hand. The oils from your hand will stick to
the bulb and may cause it to burn out faster than normal.
To Replace the Light Bulb(s):
1. replace the bulb only with Dacor part No. 92317,
available from any authorized Dacor parts dealer.
2. Turn off power to the oven at the circuit breaker panel
or fuse box.
3. hold your hand under the lens for support and gently
pry it loose using a spatula or table knife. pull the lens
cover straight out.
Care and Cleaning
warning
Optional Cookie Sheets
• Clean aluminum cookie sheets with a solution of
detergent and warm water. Since aluminum can
scratch, you need to use the soft side of a sponge. A
way for you to keep cookie sheets cleaner is to use
parchment paper over the cooking surface during
baking. The parchment paper will also prevent food
from sticking.
4. Grasp the old bulb and pull it straight out of the
socket.
5. using a glove, insert the new bulb into the socket.
6. As you reinstall the lens cover, line up the cutout on
the inside rim with the light socket. Gently press it
into its original position.
7. Turn the power to the oven back on at the main power
supply. reset the clock.
Light bulb
Lens
light Bulb replacement
32
Light socket
Cutout: line up with
light socket