Replacing The Light Bulbs - Dacor MORD230 Use And Care Manual

Replacing the Light Bulbs

warning
• To prevent electrical shock and/or personal injury, make
certain that the oven and light bulb(s) are cool and that
power to the oven has been turned off at the main power
supply before replacing the light bulb(s).
• Always make sure the lens covers are in place when using
the oven(s). The lens covers protect the light bulbs from
breakage caused by high oven temperatures or mechanical
shock.
• Use the pry stick with caution. Do not cause uneven stress
on the lens cover.
• Replacing the lens cover without lining up the cut-out with
the light socket will damage the light fixture.
Light bulb replacement is considered to be a homeowner
maintenance operation. if the lights do not work, before
replacing them, please consult the Problem Solution
Guide on page 29.
to replace the light bulbs, follow these steps:
1. turn off power to the oven at the circuit breaker or
fuse box.
2. gently insert the pointed end of the supplied lens pry
stick under the center edge of the lens cover. hold
your hand under the lens for support and pry it loose.
pull the lens cover straight out.
lens Pry
stick
3. using a glove, insert the new bulb into the socket.
replace the light bulbs only with Dacor part no.
100429, available from any authorized Dacor parts
dealer.
Care and Cleaning
27
important
Do not touch the replacement halogen light bulbs with
your fingers. Halogen bulbs are sensitive to the oils
from your hand. the oils from your hand will stick to
the bulb and cause it to burn out faster than normal.
4. when reinstalling the lens, line up the cut-out on the
inside rim with the light socket. gently press it into its
original position.
Light
bulb
5. turn the power to the oven back on at the main power
supply.
6. reset the clock (see page 8.)
Light
socket
cutout on inside
rim of lens