Downloading Firmware Via The Parallel Interface - Kyocera Mita FS-6020 Service Manual

FS-6020

(2) Downloading firmware via the parallel interface

To download the system or engine firmware using the parallel interface, use the procedure below. You can download both
the system and engine firmware at a time.
Connecting the parallel printer cable
1. Turn printer and PC power off.
2. Connect the parallel printer cable between
the PC and the printer.
Downloading the firmware files
1. Turn printer power on.
2. Confirm that display 1 is displayed.
3. At the DOS prompt, enter command 2.
* Enter UPGR'SYS' in capitals.
4. Confirm that message display 3 is displayed.
5. At the DOS prompt, enter command 4 so
that the system firmware (example:
s96K9100.bcmp) and the engine firmware
(example: E96KA005.x) are copied to the
printer.
6. Message display 5 is displayed during
downloading. When message display 6 is
displayed to indicate downloading is finished,
turn printer power off, then on.
7. Confirm that message display 7 is displayed
after warm-up.
Confirming upgrading
1. Print a status page. (See page 1-4-2.)
2. Check that the status page shows the
updated firmware version.
1-7-2
To PC
Message display
1
Ready
>echo !R! UPGR'SYS';exit;>PRN
2
Supervisor mode
3
parallel waiting
>Copy /b S96K9100.bcmp prn
4
>Copy /b E96K005.x prn
5
Downloading
Version 88.00
[System]
6
8800
02/06/07[1234] 2
Release date Checksum
Power switch: Off/On
7
Ready
Parallel
printer cable
Figure 1-7-1
PC DOS display
* Press any key to switch the display.
Model code 96=FS6020
[Engine]
96
*
02/06/07[1234] 2
Multiple data files Release date
Checksum
Figure 1-7-2
Version A005
A005
Multiple data files