Kyocera Mita FS-6020 Service Manual page 28

FS-6020
Loading paper.
1. Remove the cassette from the printer.
2. Adjust the paper guides and the paper stopper
according to the paper size to be used.
3. Set the stack of paper that does not exceed the
paper upper limit marks on the paper guides and
the paper stopper by aligning the top of the stack
and placing the rear side first. (Approximate 250
sheets of 0.1 mm thick paper can be loaded.)
4. Turn the paper size dial so that the size of the
loaded paper is indicated in the paper size
indication window.
If "OTHER" is selected, paper size setting must
be performed on the operation panel of the
printer.
5. Install the cassette into the printer.
1-3-6
Paper guides
Figure 1-3-9
Paper size
indication
window
Paper size dial
Figure 1-3-10
Paper stopper