Parallel Interface Connection - Kyocera Mita FS-1000+ Installation Manual

Ifs10ep-jp.book Page 7 Friday, December 22, 2000 4:27 PM

Parallel Interface Connection

To printer
Printer Cable
1
Plug one end of the printer cable (not
included) into the parallel interface con-
nector on the rear of the printer.
Clips
• Use a parallel printer cable
• The printer will work best if it
2
Close the clips on both sides to fix the
connector in place.
Plug the other end of the printer cable
into the computer's Centronics parallel
interface connector.
that complies with the
IEEE1284 standards.
is installed near the computer.
The connecting cable should
be shielded and not be longer
than 3 meters (10 feet).
Go to next page
7