Detaching And Refitting The Drive Assembly - Kyocera Mita FS-6020 Service Manual

FS-6020

(6) Detaching and refitting the drive assembly

Perform the following procedure when the drive assembly is to be checked or replaced.
Procedure
1. Remove the three hooks of ground springs.
2. Remove the feed clutch and middle feed
clutch.
3. Remove the four connectors from the main
PWB and one connector from the main motor.
4. Remove the four screws and then the drive
assembly.
5. Replace or check the drive assembly.
6. Refit all the removed parts.
1-6-14
Ground springs
Ground spring
Drive assembly
Screws
Middle feed clutch
Feed clutch
Figure 1-6-16
Connector
Figure 1-6-17
Connectors
Screws