FS-C5016N
(2) Downloading firmware via the parallel interface
To download the system firmware using the parallel interface, use the procedure below. Note that you can download both
the system and engine firmware at a time.
1. Turn printer and PC power off.
2. Connect the parallel printer cable between
the PC and the printer.
3. Turn printer power on.
4. Confirm that display 1 is displayed.
5. At the DOS prompt, enter command 2.
* Enter UPGR'SYS' in capitals.
6. Confirm that message display 3 is dis-
played.
7. At the DOS prompt, enter command 4 so
that the system firmware (example:
s80K9100.bcmp) and the engine firmware
(example: E80KA005.x) are copied to the
printer.
8. Message display 5 is displayed during
downloading. When message display 6 is
displayed to indicate downloading is fin-
ished, turn printer power off and then turn
on.
9. Confirm that message display 7 is dis-
played after warm-up.
10. Print a status page. (See page 1-4-2.)
11. Check that the status page shows the
updated firmware version.
1-7-2
Parallel interface connector
To PC
Message display
1
Ready
>echo !R! UPGR'SYS';>PRN
2
3
Supervisor mode
parallel waiting
4
>Copy /b S80K9100.bcmp prn
>Copy /b E80K005.x prn
5
Downloading
Version 88.00
[System]
6
8800
02/06/07[1234] 2
Release date
Checksum
Plural data
Power switch: Off/On
7
Ready
Parallel printer cable
Figure 1-7-2
PC DOS display
*: When a some key is pushed, indication changes.
Product code: 80=FS-C5016N
Version A005
[Engine]
80
A005
*
03/03/07[1234] 2
Release date
Checksum
Figure 1-7-3
Plural data