Detaching And Refitting The Fixing Thermistor And Separator - Kyocera Mita FS-6020 Service Manual

(5) Detaching and refitting the fixing thermistor and separator

Perform the following procedure when the fixing thermistor and separator are to be checked or replaced.
Procedure
1. Divide the fixing unit into the upper fixing
frame and the lower fixing frame (see page 1-
6-19).
2. Remove one screw.
3. Push the two claws and then remove the
upper eject guide.
4. Remove one screw and then the fixing
thermistor.
5. Lift the separator upwards and pull it out.
6. Check or replace the fixing thermistor and
separator.
7. Refit all the removed parts.
Upper eject guide
Claw
Fixing thermistor
Screw
Screw
Figure 1-6-27
Separator
Figure 1-6-28
FS-6020
Claw
1-6-23