Checking The State Of The Printing Heads - Roland SP-300 User Manual

Press the [HEATER CONFIG] key.
1
The heater configuration menu appears.
Press the [ ] and [ ] keys to enter the preset
2
temperature for [PRINT], then press the [EN-
TER] key.
This enables the preset temperatures for the print heater.
Press the [ ] key to move the cursor to
3
[DRYER].
In the same way as in step 2, enter the preset
4
temperature and press the [ENTER] key.
This enables the preset temperatures for the dryer.
Press the [HEATER CONFIG] key.
5
The top menu appears.

Checking the State of the Printing Heads

Before you start to print, carry out a printing test to check the state of the heads.
Problems such as missing dots may reduce the printing quality.
If the test results show a problem, carry out head cleaning to restore the heads to their proper state.
1 Press and hold the [TEST PRINT] key for at
least one second.
The test pattern is printed.
2 If dot drop-out is present, clean the heads.
For more information about head cleaning, see "5-2
Cleaning the Printing Heads."
3-1 Points to Check Before Performing Output
PRINT
DRYER
Preset
temperature
PRINT
DRYER
PRINT
DRYER
PRINT
DRYER
3. Performing Output
35 25
35 25
Actual
temperature
38 25
35 25
38 25
35 25
38 25
38 25
49