Step 6: Change The Settings For The Language And Unit Of Measurement, And Check The Voltage Settings - Roland SP-300 User Manual

Step 6: Change the Settings for the Language and Unit of Measurement, and Check the Voltage Settings

Change the settings for the language and measurement unit used for the display, and check the settings of the voltage
switches.
Switch on the main power switch on the back
1
of the machine.
2 Hold down the [MENU] key and press the
[POWER] key.
The sub power is switched on.
The screen in the figure appears on the display.
Use the [ ] key to select [ENGLISH], then press
3
the [ENTER] key.
Make sure the text shown on the display is in English.
4 Make the setting for the measurement unit used
for lengths.
Use the [ ] key to select [mm] or [INCH], then
press the [ENTER] key.
5 Make the setting for the measurement unit used
for temperatures.
Use the [ ] key to select [ºC] or [ºF], then press
the [ENTER] key.
After a short interval the screen shown in the
6
figure appears.
Make sure the two voltage switches are set
correctly, then press the [ENTER] key.
If the voltage switches have not been set correctly, then stop operation.
Follow the steps below to set the voltage switches, then start over from the beginning.
1. Press the [POWER] key to switch off the sub power.
2. Switch off the main power switch.
3. Refer to the previous section, "Set the Voltage Switches," and make the settings for the voltage switches.
1-3 Assembling and Installing
Switch to the "I" side.
MENU LANGUAGE
ENGLISH
LENGTH UNIT
mm mm
TEMP. UNIT
º º
C C
CHECK HEATER
VOLTAGE SETTING
1. Getting Started
27