Step 9: Install the Blade
Never touch the tip of the blade with your fingers.
Doing so may result in injury, and the cutting performance of the blade will be impaired.
Never leave the tool-mounting screw tightened. Tightening the screw makes it more difficult to install the blade holder.
Install the blade to the cutting carriage.
Insert the pin into the blade holder.
1
Insert a blade into the blade holder until it snaps
2
into place with an audible click.
Press the [MENU] key, then press the [ ] key
3
to select [REPLACE KNIFE].
4
Press the [ENTER] key.
When the forrowing screen appears, the printing carriage
simultaneously moves to the left.
Open the front cover, then loosen the screw
5
shown in the figure.
Support the tool-mounting screw from below
6
and install the blade holder.
If installed without supporting the screw in this way,
cutting quality may become poor.
Tighten the screw.
7
Tug the blade holder upward to make sure it does not
come loose.
Close the front cover, then press the [ENTER]
8
key.
1-3 Assembling and Installing
Pin
Blade holder
Cap
Pin
Blade holder
Blade
MENU
REPLACE KNIFE
FINISHED?
Screw
Insert the blade holder
until the collar is flush
with the carriage.
Screw
1. Getting Started
31