Using The Secure Shell Server; Using The Configuration File; Backing Up Your Current Configuration - IBM BladeCenter Management Module User Manual

2. Scroll to the Secure Shell (SSH) Server section. A page similar to the one in the
3. Click Enabled in the SSH Server field.
4. In the navigation pane, click Restart ASM to restart the management module.

Using the secure shell server

If you are using the secure shell client that is included in Red Hat Linux version 7.3,
to start a secure shell session to a management module with network address
192.168.70.2, type a command similar to the following example:
ssh -x -l USERID 192.168.70.2
where -x indicates no X Window System forwarding and -l indicates that the session
should use the user ID 'USERID'.

Using the configuration file

Use the management-module Web interface MM Control → Configuration File to:
v Back up the management-module configuration
v Restore the management-module configuration
Note: If you cannot communicate with a replacement management module through

Backing up your current configuration

You can download a copy of your current management-module configuration to the
client computer that is running the management-module Web interface. Use this
backup copy to restore your management-module configuration if it is accidentally
54
BladeCenter Management Module: User's Guide
following illustration is displayed.
the Web interface or the IBM Director programs, the IP address might be
different from the IP address of the management module just removed.
Press the IP reset button to set the management module to the factory
default IP addresses; then, access the management module using the
factory IP address (see "Configuring the management module for remote
access" on page 8 for the factory IP addresses) and configure the
management module or load the saved configuration file.