Network Protocols - IBM BladeCenter Management Module User Manual

v Internal Network Interface (eth1) - This interface communicates with the
v TCP log - Select this choice to view entries that are currently stored in the
Click on View Configuration Summary to display the configuration settings for all
BladeCenter users and components.

Network Protocols

Select the Network Protocols choice to view or change the settings for the SNMP,
DNS, SMTP, and LDAP protocols.
Click on View Configuration Summary to display the configuration settings for all
BladeCenter users and components.
Some of the Network Protocol settings are used during SNMP, SMTP, and LDAP
configuration. See "Configuring SNMP" on page 35, "Configuring SMTP" on page
37, and "Configuring LDAP" on page 38 for additional information.
32
BladeCenter Management Module: User's Guide
network-interface I/O modules, such as an Ethernet I/O module or the Fibre
Channel I/O module.
– Specify the IP address to use for this interface. The subnet mask must be the
same as the subnet mask in the external network interface (eth0).
– View the data rate, duplex mode, maximum transmission unit (MTU),
locally-administered MAC address, and burned-in MAC address for this
interface. You can configure the locally-administered MAC address; the other
fields are read-only.
management module TCP log. This log contains error and warning messages
generated by the TCP/IP code running on the management module, and might
be used by your service representative for advanced troubleshooting. The log
displays the most recent entries first.
You can sort and filter entries in the event log.