Blade Tasks; Power/Restart - IBM BladeCenter Management Module User Manual

Blade Tasks

Select the choices in the Blade Tasks section to view and change the settings or
configurations of blade servers in the BladeCenter unit.

Power/Restart

Select Power/Restart choice to perform the following actions on any blade server in
the BladeCenter unit.
Note: You cannot perform these actions on an On Demand blade server with a
v Turn on or turn off the selected blade server (set the power state on or off).
v Enable or disable local power control. When local power control is enabled, a
v Enable or disable the Wake on LAN feature.
v Restart the blade server or the service processor in the blade server.
v See which blade servers are currently under the control of a remote console
Select the blade servers on which you want to perform an action; then, click the
appropriate link below the table for the action you want to perform.
Standby status (identified by an X in the SCOD column). To activate an On
Demand blade server, see the instructions in the On Demand choice
described in "On Demand" on page 20.
local user can turn on or turn off the blade server by pressing the power-control
button on the blade server.
(identified by an X in the Console Redirect column).
Chapter 3. Using the management-module Web interface
19