Configuring Smtp - IBM BladeCenter Management Module User Manual

10. If a DNS server is available on your network, scroll to the Domain Name
11. If a DNS server (or servers) is available on your network, select Enabled in
12. If you enabled DNS, in the DNS server IP address fields, you can specify the
13. Scroll to the bottom of the page and click Save.
14. In the navigation pane, click MM Control → Restart MM to activate the

Configuring SMTP

Complete the following steps to specify the IP address or host name of the Simple
Mail Transfer Protocol (SMTP) server.
Note: If you plan to set up an SMTP server for e-mail alert notifications, be sure
1. Log in to the management module where you want to configure SMTP. For
2. In the navigation pane, click MM Control → Network Protocols and scroll down
Note: If an error message window opens, make the necessary adjustments to
the fields listed in the error window. Then, scroll to the bottom of the
page and click Save to save your corrected information. You must
configure at least one community to enable this SNMP agent.
7. In the Community Name field, enter a name or authentication string to specify
the community.
8. In the corresponding Host Name or IP Address field, enter the host name or
IP addresses of each community manager.
9. If a DNS server is not available on your network, scroll to the bottom of the
page and click Save.
System (DNS) section. A page similar to the one in the following illustration is
displayed.
the DNS field. The DNS field specifies whether you use a DNS server on your
network to translate host names into IP addresses.
IP addresses of up to three DNS servers on your network. Each IP address
should contain integers from 0 through 255, separated by periods.
changes.
that the name in the Name field in the MM Information section of the MM
Control → General Settings window is valid as part of an e-mail address (for
example, there are no spaces).
more information, see "Starting the management-module Web interface" on
page 12.
to the Simple Mail Transfer Protocol (SMTP) section.
Chapter 3. Using the management-module Web interface
37