Outside Air Installation - Quadra-Fire Edge60 Owner's Manual

Zero clearance pellet fireplace nutural/curved/tuscan/studio
Table of Contents

Advertisement

R
R R
I. Outside Air Kit Installation
Outside air is required on all installations. The Outside
Air Kit must be ordered seperately.
CAUTION! Risk of Fire or Asphyxiation! Do not draw
outside combustion air from wall, floor or ceiling cavity, or
enclosed spaces such as an attic or garage.
• Do not place outside air inlet close to exhaust vents
or chimneys. Fumes or odor could be drawn into the
room.
• Locate outside air inlet to prevent blockage from
leaves, snow/ice, or other debris. Blockages could
cause combustion air starvation.
Install Outside Air Kit
Keep duct runs short and straight to minimize restriction.
The outside air kit can be installed in three different
locations - the left or right side or from the back. Figure
42.1 on page 42.
Locate the air inlet in a clear area, preferably into prevailing
wind during the heating season. Figure 42.2 on page 42.
Install as shown in Figure 43.1.
The air duct may be run vertically.
April 9, 2009
Included in Kit:  wire ties, 1 collar assembly, 1 termina-
tion cap assembly, 1 trim ring, fasteners.
NOTE:
THREE INCH ALUMINUM FLEX PIPE NOT SUPPLIED.
Tools Needed: Phillips Head screwdriver; wire cutters;
hole saw or jig saw.
1. Measure distance from floor to air vent opening in appli-
ance and mark location on wall.
Use saw to cut opening in wall.
• Cut a -1/ to 4 inches (89-10mm) opening on inside
wall.
* Cut a 4 to 4-1/ inches (10-114mm) opening on out-
side of house.
. Use wire tie to secure flex pipe to collar assembly.
. Slide trim ring over flex pipe and run pipe through wall.
4. Attach flex pipe (not supplied) to outside termination
cap with second wire tie.
5. Secure termination cap to outside surface.
Rear Installation Show in Drawing
Flexible Duct
(not supplied)
Outside Air
Shield
2 Wire Ties
Hearth & Home Technologies Inc recommends using
Figure 43.1 - Outside Air Installation
UL181 Class 0 or Class I rigid or flexible ducting.
7051-158
EDGE 60 Pellet Fireplace
Outside Air
Plate
Assembly
Page 4

Advertisement

Table of Contents
loading

Table of Contents