Quadra-Fire Edge60 Owner's Manual page 36

EDGE 60 Pellet Fireplace
Vertical Installation (Cont'd)
Pipe
Liberally silicone
all around flue
collar before
inserting into pipe
Figure 36.1
Drill Holes for Screws
above Locating Pins
X
Locating Pin
on Each Side
Figure 36.2
Secure in place
with 4 screws
Figure 36.3
Attach rear cover plate with hole
at the top and secure in place.
Figure 36.4
Page 6
Flue Collar
Top Cover Plate
Insert assemblied pipe
and flue collar through
top of outer can and over
gasket.
Secure top cover
plate in place.
Horizontal Installation
1. Remove the flue collar and orange gasket from the com-
ponent pack. Push out the 6 slugs in the gasket.
. Remove the rear cover plate. Save screws and plate for
later re-attachment.
. Place the orange flue gasket over the locating pins on
the exhaust flue transition on the back of the fireplace.
Figure 35.2 on page 35.
4. Position the flue collar over the gasket and secure in
place. Figure 36.5.
5. Position the rear cover plate,secure in place. Figure 36.6.
6. Before placing the pipe over the flue collar, liberally sili-
cone the end of the flue collar with RTV 6500 Hi-Temp
silicone about 1-1/ inches (8mm) wide.
7. Drill holes through the pipe walls directly into the flue
collar one on each side, 180 degrees apart. Screw the
pipe to the flue collar with  screws, . Figure 36.7.
Locating Pins each Side
Flue Collar in Horizontal Position
Figure 36.5
Secure pipe to flue collar with 2
screws, 180 degrees apart
Figure 36.7
7051-158
Rear Cover Plate
Installed with Hole
at the Bottom
Figure 36.6
Liberally silicone flue collar
before placing pipe over collar.
April 9, 2009
R