Convection Blower; Baffle Removal & Replacement - Quadra-Fire Edge60 Owner's Manual

EDGE 60 Pellet Fireplace
C. Convection Blower Replacement
1. Follow the proper shut down procedures as outlined on
page 14, Section 3.A.
. Remove the  bolts from the bottom left and right side
of the fireplace and slide the fireplace out.
. Locate the convection blower on the bottom left rear of
the fireplace. Reach behind the blower and release the
latch by pushing the top of the latch towards the blower.
Figure 50.1.
4. Rock the top of the blower slightly and lift up and out.
The blower will pass around the control board and out
the side of the fireplace.
5. Disconnect the wire harness from the bottom of the
blower by depressing the tabs on the sides of the con-
nector and then pulling to remove.
6. Re-connect wire harness to the new replacement
blower. Install the blower by placing the bottom flange
into the opening first then rotate blower up into posi-
tion.
7. When the blower is properly positioned the latch will engage
the notch to hold the blower in place. Figure 50.2.
8. Slide appliance back in position and re-install bolts.
Release the Latch
Figure 50.1
Figure 50.2
Page 50
D. Baffle Removal & Replacement
WARNING! Risk of Injury! Cast iron is a very heavy
material. The baffle is made of cast iron and therefore is
heavy and awkward at times to maneuver. Clear and prepare
your work area before you begin.
1. Follow the proper shut down procedures as outlined
on page 14, Section 3.A.
. Open front and open firebox door.
. The baffle is located at the top inside of firebox.
4. To remove the baffle:
a. Place a flat head screwdriver into the slot of the
latches located in the upper corners. Figure
50.3.
b. Push down and the bottom of the latch will fall
forward off of the post.
c. Lift the baffle up and then out toward you.
5. To replace the baffle:
a. Place the  locating ears behind the bottom edge.
b. Tilt the baffle up and into place.
The baffle must be centered in the firebox before
latching it in place.
c. If it is not centered the latch is trapped between
the baffle and side of the firebox instead of latch-
ing properly.
d. The bottom of the latches will fit over the posts.
e. Push the top of the latch forward to lock latch into
place.
Baffle
Insert flat head screw driver into "V"
section and push down and the bottom
of the latch will fall forward off of post
Figure 50.3
7051-158
Latches
Locating ears - 1 on
each side. Fit behind
bottom edge.
April 9, 2009
R