Section 11: Replacement Parts; Combustion (Exhaust) Blower - Quadra-Fire Edge60 Owner's Manual

R
R R
11
Replacement Parts
A. Glass Replacement
WARNING! Risk of Injury!
• Glass is 5mm thick high temperature heat-resistant ceramic
glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause injury
1. To remove the door:
a. Swing open the front.
b. Remove the door by lifting it off the hinge pins.
c. Lay on a flat surface face down.
2. Using a Phillips head screwdriver, remove 4 screws, 
on the top and  on the bottom. Figure 49.1.
. Remove metal bracket.
4. Remove the glass.
5. Replace with new glass with gasket.
6. Re-attach metal bracket with 4 screws.
7. Re-install door over hinge pins and close front.
Remove 4 screws
Figure 49.1
April 9, 2009
Metal Bracket
Glass with Gasket
7051-158
B. Combustion (Exhaust) Blower
Replacement
1. Follow the proper shut down procedures as outlined on
page 14, Section 3.A
. The combustion blower is mounted in the lower right
rear of the appliance. Figure 49.2.
. Use an 11/ nut driver to loosen all six nuts, but do
not remove. Rotate the blower and remove from the
housing. Figure 49.3.
4. Disconnect the wires.
5. You will also need to replace the gasket, see service
parts list for part number.
6. Install replacement blower in reverse order and re-con-
nect the wires.
Combustion Blower Located
Right Lower Side of Fireplace
Combustion Blower
Figure 49.2
Loosen all 6 nuts, but do NOT Remove
Figure 49.3
EDGE 60 Pellet Fireplace
Page 49