Table of Contents
Advertisement
CP305
1.3
Optional Modules
1.3.1
CP305-HDD Module
The CP305-HDD module for the 8 HP CP305 version provides legacy PC I/O ports. It includes
one digital DVI port, two USB 2.0 ports, one COM port, a PS/2 keyboard and mouse port, one
IDE connector, and one CompactFlash socket. A SATA hard disk interface is also available for
mounting a 2.5" hard disk drive.
Refer to Appendix A for further information on the CP305-HDD module.
1.3.2
CP-RIO3-04 Rear I/O Module
The CP-RIO3-04 rear I/O module has been designed for use with the CP305 board from
Kontron and provides comprehensive rear I/O functionality.
For further information concerning the CP-RIO3-04 rear I/O module, refer to Appendix B.
1.4
System Relevant Information
The following system relevant information is general in nature but should still be considered
when developing applications using the CP305.
Table 1-1:
System Relevant Information
SUBJECT
System Configuration
Master/Slave Functionality
Board Location in the System
Hot Swap Compatibility
Hardware Requirements
Operating Systems
1.5
Board Diagrams
The following diagrams provide additional information concerning board functionality and
component layout.
ID 1035-7168, Rev. 1.0
The CP305 system controller board can support up to 7 peripheral boards with 32-
bit and 33 MHz.
The CP305 can operate only as a master board.
The CP305 board must be installed in a system slot of a CompactPCI backplane.
The CP305 supports the addition or removal of other boards whilst in a powered-
up state. Individual clocks for each slot and ENUM signal handling are in compli-
ance with the PICMG 2.1 Hot Swap specification.
The CP305 can be installed in any CompactPCI 3U rack.
There are various operating systems available for the CP305. For detailed infor-
mation, please contact Kontron.
Introduction
INFORMATION
Page 1 - 5
Advertisement
Table of Contents
