Shock absorbers
Shock absorbers
Removal
1. Raise the seat to the highest position. If the wheelchair is equipped with a fixed seat post or if the
seat lift does not work normally because the batteries are discharged or the adjustment device is
defective, the seat can be raised/lowered manually. See page 29.
2. Switch off the main power switch on the control panel.
3. Remove the chassis covers. See page 7-8.
4. Lift up and chock up the wheelchair chassis so that the wheel in question is free of the ground.
6. Remove the shock absorber, it's fitted with two screws (see fig. below).
Assembly
Assemble in the reverse order.
1. Lubricate the bearing points of the shock absorber with grease before fitting.
2. Fit the shock absorber using the two screws and washers (see fig. below).
3. Adjust the shock absorber spring force. See page 21.
4. Remount the chassis covers. See page 7-9.
For this task the following tools are necessary:
1
Fitting/removing the Shock absorber.
20
Allen key 6 mm.