Seat - Permobil M300 Corpus HD Service Manual

Seat

Seat
Removal
1. Raise the seat to the highest position. If the
wheelchair is equipped with a fixed seat
post or if the seat lift does not work normally
because the batteries are discharged or the
adjustment device is defective, the seat can be
raised/lowered manually. See page 29.
2. Switch off the main power switch on the
control panel.
3. Remove the cushion from the seat.
4. Remove the seat plates, which are held in place
by two screws at the back edge and two quick-
mount clamps at the front. See the illustration.
First remove the screws, then use your hand
to carefully push the seat plate from below to
release the quick-mount clamps at the front.
5. Remove the control panel. Loosen the control
panel cabling from its fixing points. Remember
how the cabling is positioned; this helps when
you come to re-attach it.
6. On wheelchair equipped with seat tilt, separate
the cabling for the seat angle mechanism at
the contact on the cabling. The contact is at the
front right corner of the seat angle mechanism,
next to the other cabling (see fig.).
7. Remove the four screws that hold the seat
in place (see fig.). The seat can be mounted
in three different positions, depending on the
currant seat depth. Note the position the seat
is mounted in for future reference.
8. Lift the seat off the seat lift/seat column.
m WARNING!
The seat is heavy. This work should therefore
always be performed by two people. Be careful
with the cabling.
For this task the following tools are necessary:
1 Allen key 5 mm.
1 Allen key 6 mm.
The seat plates are held in place by two
screws at the back edge and two quick-mount
clamps at the front.
The connector is on the cabling at the front
right corner of the seat angle mechanism, next
to the rest of the cabling
The seat is held in place by four screws.
46