Covers
Fitting the drive motor covers
1. On wheelchairs equipped with lights and
indicators, connect the indicators cabling at the
contact on the cabling. This is positioned on the
inside of the chassis, next to the seat lift.
2. Install the brake release cover using the screw
(see fig.).
3. Replace the Drive motor cover with the two
screws as per diagram.
4. On wheelchairs equipped with lights and
indicators, Remount the front and upper chassis
cover. (See page 8-9).
For this task the following tools are necessary:
1
Allen key 3 mm.
1
Allen key 2,5 mm.
The connector on the front indicator cabling.
The brake release cover is fitted
with one screw.
The drive motor cover is fitted with two screws.
13
Covers