Replacing The Legrest Strap - Permobil M300 Corpus HD Service Manual

Repairs
Replacing a legrest strap
For this task the following tools are necessary:
1 Allen key 3 mm
1 Steel ruler
m WARNING!
Do not subject the legrest to load during
mounting or removal. Risk of crushing.
Removal
1. Switch off the main power switch on the control
panel.
2. Lift up the legrest's top cover. See the illustration.
3. Remove one end of the legrest strap by
carefully raising the lower section of the
legrest slightly and at the same time removing
the two screws on the front of the legrest.
Then pull the mounting plate out of the loop
of the strap.
Once the strap is loosened the lower section
of the legrest will become loose and can be
carefully placed on the floor.
4. Remove the two screws holding the strap
bracket on the back of the legrest in place.
See the illustration.
5. Pull the strap out of the legrest mechanism.
Mounting
1. Pull the strap through the bracket on the back
of the legrest. Measure to make sure that
the strap extends 85 mm from the bracket.
Secure the strap by tightening the two screws
on the bracket. See the illustration.
2. Slide the lower section of the legrest up and
pull the strap through the legrest mechanism.
See the illustration.
3. Place the mounting plate in the loop of the strap
and then mount this on the front of the legrest
using the two screws. See the illustration.
Strap mounting on the legrest
84
Replacing a legrest strap
Lift up the legrest's top cover