Optional Controllers - Empire Comfort Systems Mantis FF28BMN-1 Installation Instructions And Owner's Manual

Power-vent high-efficiency fireplace

Hide thumbs

Table Of Contents

Table of Contents

FRBTP

FRBTC

TRW

TMV2

T24V

TDV1

See your Mantis dealer for correct controller type.

INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION

Installation Instructions for FRBTP, FRBTC, and TRW

Remote Controls FRBTP, FRBTC and TRW are all battery operated devices. Begin installation by unplugging the unit and removing

the front louver panel.

Remove wire nut from black and white wire from junction box.

Black or white wire can be inserted in either remote control receiver connection hole or connected to T24V thermostat screws. There is

no polarity at this connection.

Replace front louver panel and plug unit into outlet. Turn both burner switches to the ON position. Burner switches must remain in the

ON position for remote to function. Set remote from the instructions provided with the remote control. Set T24V thermostat to desired

temperature.

Note: When the heater will not be used for long periods, the burner switches should be in the OFF position, and the heater should be

turned off at the power point.

Installation Instruction for TMV2 - Two Stage Thermostat Model:

Begin installation by unplugging the unit and removing the front louver panel.

Determine mounting location of thermostat. Using standard 18 AWG wire, run four (4) strands of wire into rear of Mantis

(See Figure 69) to junction block. Cut wire to correct length. Remove blue jumper wire from junction block and save for future use.

Connect four (4) new thermostat wires to Mantis using schematic. See Figure 70.

25700-1-0809