Maintenance - Empire Comfort Systems Mantis FF28BMN-1 Installation Instructions And Owner's Manual

Note: Your appliance should be inspected, serviced and
checked annually by a qualified service person to
ensure that your appliance is operating safe and
efficiently. Should you detect any abnormality in the
operation of your appliance call a qualified service
person who has been trained and approved to inspect
and service the appliance. This may be your installer or
dealer (routine service is not covered under warranty).
Front door removal drawing
25700-1-0809

MAINTENANCE

Figure 74
Glass Cleaning
It will be necessary to clean the glass periodically. During
start-up, condensation, which is normal, forms on the inside of
the glass and causes lint, dust and other airborne particles to cling
to the glass surface. Also, initial paint curing may deposit a slight
film on the glass. It is therefore recommended that the glass be
cleaned two or three times with a non-abrasive household cleaner
and warm water (we recommend gas fireplace glass cleaner) after
the initial burn. We do not recommend using packaged spray type
household glass cleaner. After that, the glass should be cleaned
two or three times during each heating season depending on the
circumstances present.
General Glass Information
Only glass approved for use in Empire Comfort Systems, Inc.
fireplace may be used for replacement. The glass replacement
must be done by a licensed or qualified service person.
WARNING:
1. The use of substitute glass will void all product warranties.
2. Care must be taken to avoid breakage of the glass.
3. Under no circumstances should this appliance be
operated without the glass front or with a broken glass front.
Replacement of the glass (with gasket) as supplied by the
manufacturer must be done by a qualified service person.
4. Do not abuse the glass by striking or hitting the glass.
WARNING: Do not use abrasive cleaners on glass. Do not
attempt to clean glass when glass is hot.
Glass Assembly Replacement
Removal
1. Remove lower louver panel by lifting up and pulling out.
2. Release two (2) hinge clips on underside of firebox.
3. Angle bottom of glass assembly approximately 60 degrees
out from firebox. Gently pull glass assembly away from
firebox.
Replacement
4. Insert the tabs on top of new glass assembly into the slots on
top of the firebox and gently lower the glass assembly down.
5. Attach and tighten the two (2) hinge clips on underside of
firebox.
6. Replace lower louver panel.
Page 45