Table of Contents
Advertisement
When installed and operated as described in these instructions, this wood fireplace is suitable
for use in residential installations.
In Canada, the CSA B365 «Installation Code for Solid Fuel Burning Appliances and Equipment»
and the CSA C22.1 «Canadian National Electrical Code» are to be followed in the absence of
local code requirements. In the USA, the ANSI NFPA 211 «Standard for Chimneys, Fireplaces,
Vents and Solid Fuel-Burning Appliances» and the ANSI NFPA 70 «National Electrical Code» are
to be followed in the absence of local code requirements.
This fireplace is not approved for use with a so-called "positive flue connection" to the clay
tile of a masonry chimney.
8. Fireplace Installation
8.1
Standoff Installation
Before installing the fireplace, it is mandatory to install the standoffs on the top (L) , on the
sides and (O) and (P) the back (N) of the fireplace. The standoffs can be found in the fireplace
firebox and and the screws (M) to install them can be found in the fireplace manual.
8.2
Optional Carrying Handles
To facilitate the transport of the fireplace, handles sold as an
option may be used. They are installed on each side of the
fireplace. Wearing gloves is strongly recommended when moving
the fireplace.
Page 30
Installation and Operation Manual - St. Clair 3000
Advertisement
Table of Contents
