Wall Mounting Your Telstra V580/V580A; Fitting The Bracket To Wall Mount The Phone - Telstra V580 User Manual

Wall mounting your Telstra V580/V580a

Your telephone base comes with the bracket installed, ready for desktop use. If you prefer to mount your telephone on the wall, it is designed to mount on a standard
Telstra wall mount plate.

Fitting the bracket to wall mount the phone

1. First, insert the lower portion tabs of the wall mounting bracket into the lower grooves in the telephone base, then snap the upper portion tabs of the wall mounting
bracket into place.
2. Mount the telephone base on the wall by positioning it so the mounting studs will fit into the holes on the telephone base and wall mounting bracket. Slide the
telephone base down on the mounting studs until it locks into place.
3. To remove the bracket, press both upper portion tabs firmly inward and pull the bracket downward until it release from the grooves.
Alternatively to wall mount the phone:
1. Using the template on page 43, drill two 3mm holes. Insert plastic plugs (optional) and partially screw the two screws into place. Ensure there is sufficient space allowed
for mounting the phone before drilling holes.
Caution: Ensure there is no risk of damaging any pipes or wiring that may be behind the wall.
2. Place the wall mount bracket over the two screws.
3. Slide the bracket downwards into position. Tighten the two screws to prevent the wall bracket from moving.
10