Set Number Of Rings; Set Base Ringer; Set Remote Access Code - Telstra V580 User Manual

Using the answering machine (Telstra V580a only)
NOTE: Press and hold or
date. You'll need to set the year so the day of the week can be determined from the Calling Number Display information. The time will be set automatically only if you
subscribe to Telstra's Calling Number Display. Setting this clock will not affect the handset clock, they are individual settings.

Set number of rings

This feature allows you to select the number of rings before the answering system answers. You can choose from two, four or six rings or toll saver. With toll saver active, the
answering system answers after two rings when there are new messages, and after four rings when there are no new messages.
To set the number of rings:
1. Press in idle mode, and the system announces the number of rings setting.
2. Press or until the system announces the desired setting, then press
idle mode.

Set base ringer

This feature allows you to select from three telephone base ringer volume levels: high, low or off.
To set the base ringer:
1. Press in idle mode until the system announces the base ringer setting.
2. Press or until the system announces the desired base ringer volume level, then press
save and return to idle mode.
NOTE: When calling remotely to check for messages, select toll saver in number of rings setting will help to save long distance charges because the answering system will
answer the incoming call after two rings when there are new messages.

Set remote access code

A two-digit security code is required to access the answering system from any touch tone telephone. The factory default code is 19. To set the remote access code:
1. Press in idle mode until the system announces the remote access code setting.
2. Press or to change the remote access code by one, or press and hold
the next setting or press to save and return to idle mode.
during set up to advance by increments of ten in setting minute and year. Incoming Calling Number Display data sets the time and
to save the setting and go to the next setting or press
to save the setting and go to the next setting or press
to change by increments of 10. Press
to save and return to
to
to save the setting and go to
29