Barco iCon H600 Owner's Manual page 37

Image 4-24
1 Function keys
2 MENU
3 Address key
4 LOGO key
5
PAUSE
6 STBY
7 MUTE
8 AUTOIMAGE
9 Digit buttons
9b SOURCE button
10 Lens control
11 VOL
12 Picture controls
R5976821 BARCO ICON 15/03/2007
user programmable keys with functions for direct access.
Menu key, to enter or exit the Tool bar menu.
(recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
not implemented
to stop projection for a short time, press 'PAUSE'. The image disappears but full power is
retained for immediate restarting.
standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to
go to standby, press the standby key for 2 seconds.
to interrupt the sound reproduction (audio = optional.
Auto image, to center the image on the active LCD surface.
direct input selection.
the Source Selection menu is opened
use these buttons to obtain the desired ZOOM, SHIFT, FOCUS.
use this button to obtain the desired sound level (audio = optional)
use these buttons to obtain the desired picture analog level.
4. Installation
31