GeoVision GV-Data Capture V3 User Manual page 37

Gv-data capture v3 series

Hide thumbs Also See for GV-Data Capture V3:

Table of Contents

2. Check if the baud rates of the GV-Data Capture, POS system and GV-System are the

same. For the baud rate setting in the GV-Data Capture, see 2.2 Baud Rate Setup. For

the baud rate setting in the GV-System, see 3.2 Configuring GV-System.

3. If the network environments of the GV-Data Capture and GV-System have

implemented NAT or Firewall, open the port 80 for the web connection and port 4000

for data transmission.

Find out the dynamic IP address of your POS system.

There are two ways to find out the dynamic IP address of your POS system:

1. Click the Browse Device Setting button (see Figure 20) to see the IP address on the

IE browser.

2. Go to Windows Start, click Run, type the file name "enpos.ini" in the field, and press

OK.

The "enpos.ini" file appears as shown below, and you will see the IP address of the

POS system.

For more questions, please visit our website:

http://www.geovision.com.tw/english/faq/POSflowchart/posflow-1_new.htm

Figure 27

Troubleshooting

Table of Contents

Need help?

Do you have a question about the GV-Data Capture V3 and is the answer not in the manual?

Gv-data capture v3e Gv-data capture v3.1e