Specify A New Boot Image Through The Cli; Reboot The System - HP zl User Manual

102
Topspin-360# dir image
=========================================================================
=========================================================================
slot date-created
-------------------------------------------------------------------------
1 Tue Feb 25 16:14:15 2003
1 Thu Jan
1 Tue Feb 25 16:17:04 2003
Topspin-360#
boot-config primary-image-source image-directory-name
Topspin-360# configure
Topspin-360(config)# boot-config primary-image-source
TopspinOS-1.1.3/build497
Topspin-360(config)# exit
Topspin-360# show boot-config
=========================================================================
=========================================================================
last-image-source : TopspinOS-1.1.3/build491
primary-image-source : TopspinOS-1.1.3/build497

Reboot the System

Specify a New Boot Image Through the CLI

1. Find the name of your new system image by listing all the image files on the Topspin chassis. Enter
the dir image command.
Existing Boot-Images on System
1 00:18:52 1970
2. Copy the displayed system-image (this will be pasted into the boot-config command).
3. Specify the new boot image.
Enter boot-config
primary-image-source
name.
Syntax:
Example
4. Show the new system -image.
Example
System Boot Configuration
slot-id : 1
sw-version : TopspinOS-1.1.3/build491
The complete reboot process is described in the other chapters.
• Reboot the system through the GUI (refer to
• Reboot the system through the CLI (refer to
size file-name
23198989 TopspinOS-2.0-build491
1024 TopspinOS-2.0/build491
1024 TopspinOS-2.0/build497
, then paste the then paste the copied image file
page
page
37).
43).