Set Ib Interface Speed To Auto-Negotiate; View The Ib Interface Speed; Notifying Users - HP zl User Manual

40
Topspin-360> enable
Topspin-360# config interface ib all speed 4x
Topspin-360> enable
Topspin-360# config
Topspin-360(config)# interface ib all
Topspin-360(config-if-ib-1/1-1/12)# auto-negotiate
Topspin-360(config-if-ib-1/1-1/12)#
Topspin-360> enable
Topspin-360# show interface ib 15/1
===============================================================
==============================================================
auto-negotiate-supported : yes
***************************************************************

Notifying Users

3. Enter the following command:
config interface ib [{IB switch card/IB switch port | all }speed 1x | 4x ]
Example

Set IB Interface Speed to Auto-Negotiate

Set the InfiniBand interface speed to auto-negotiate if you want the speed of the transmit port and the
receiving port to automatically negotiate the highest possible speed. IB speed can be set on an
individual port basis, or all at once.
1. Enter the following command:
config interface ib [{IB switch card/IB switch port | all }auto-negotiate]
Example

View the IB Interface Speed

View the current speed of the InfiniBand interfaces:
1. Enter the following command:
show interface ib [IB switch card/IB switch port | all]
Example
InfiniBand Interface Information
....
....
auto-negotiate : enabled
admin-speed : 10gbps
oper-speed : unknown
....
....
User notification commands send text messages to the terminal screens of all CLI users or to individual
users. These are convenient utilities for notifying everyone of an impending reboot or to notify single
users about special issues that apply only to them.