Gui Management; Snmp Management; (Optional) Enable Database Sync; Configure Partitions - HP zl User Manual

(Optional) Enable Database Sync

Configure Partitions

To run the CLI remotely:
1. Open a terminal or terminal emulator window. For example: from the command line, enter the
command with the IP address, or network name, of the Management-Ethernet port.
telnet
# telnet 10.0.0.47
The CLI login prompt (
2. Enter a CLI user name.
The CLI password prompt (
3. Enter the CLI user password.
The prompt changes to indicate a successful login. The HP 24-Port 4x Fabric Copper Switch
system is now ready to receive CLI commands.
Remote SSH Login
TopspinOS supports SSH2 for secure, encrypted login to the switch CLI. SSH is enabled by default,
and does not require additional configuration.
1. To login via SSH, use an SSH client (e.g. Putty) to port 22.

GUI Management

1. Refer to "About Element Manager" on page 24
CLI.
2. Run the Element Manager (GUI) over a TCP/IP network.
3. To log in to the GUI, refer to

SNMP Management

For more information regarding SNMP, refer to
Any Network Manager running the Simple Network Management Protocol (SNMP) can manage the
Topspin system, if the Management Information Base (MIB) is installed correctly. By default, the
Topspin GUI is a network manager and uses SNMP v2c as the protocol to communicate between the
chassis and the management workstation.
If you are configuring more than one InfiniBand chassis in your fabric, it is likely that you will want to
enable database synchronization of the subnet managers.
• To enable data synchronization with the Element Manager GUI, refer to
Synchronization" on page
• To enable data synchronization with the CLI, refer to
on page 84.
Partitions are described in detail in
) is displayed.
Login:
) is displayed.
Password:
for more information about managing through the
"Starting the Element Manager" on page
"About SNMP" on page
66.
"About Partitions" on page
29.
30.
"Enable/Disable Database
"Enable/Disable Database Synchronization"
53.
15